Looking into Rangers!
Hey everyone! Recently been on craigslist looking for a truck and came across one that needs breaks all around including calipers, rotors and pads. Have yet to test drive it, but I was wondering if...
View ArticleOnly runs in start position!
I just recently solved some fuel issues with my 2.9l 87 ranger, replaced a fuel line and the pump relay was bad The truck starts up and runs until I let off the key to take it from start position to...
View Articleford 2.9 swap
I got a 2.9 for ranger 88 and I was wondering what would be the best mpg/power change over for the engine
View Articlehydraulic clutch advice?
Hi everyone. Not familiar with the nuances of hydraulic clutch systems so I am looking for advice from the forum members. My son has a '84 Ranger, 4x2, 2.8L V6 with a 4 spd manual tranny. Just ready to...
View ArticleThe Cursed Ranger
This is my intro and i have a question tied too it also, my question is what brought me here so if someone wants to direct me elsewhere thats okay. Hello all! Here is a brief introduction. This story...
View ArticleClik here to view.
Switch panel
Just finished installing my switch panel to control a handful of lights. Here is the final installation. Photobucket Link - 6 switches, 5 installed. 3 position: on, slave, and off - Red switch serves...
View ArticleA/C
I've got a 97 ranger 4x4 4.0 5 speed. The air conditioner was workin fine one day then the next it quit blowin cold. What could be causing the problem?
View ArticleElectric Window Problem
The electric driver side window rolls up and down fine. However, when it's done rolling up it makes a loud noise as if it's trying to roll up further. I'm also hearing more road noise now, which makes...
View ArticleStrange fuel relay issue 87 ranger
I've gotten everything finally going on this truck except one issue with the fuel relay. Everything worked with the relay jumped, jumped the 1 and 4 terminals together and the 2 and 3 terminals...
View ArticleRough Idle
This isn't on my truck but on Kyles truck. It's also a 98 with the 4.0l. But he's been having a really rough idle that shakes the whole truck for close to 4 months now. And he keeps throwing parts at...
View ArticleMaximum tire size for 2008 ford ranger xlt 4x4
I have a 2008 ford ranger xlt 4x4 and was wondering what is the maximum tire size I can put on my truck with out having to do a torsion bar lift or have any rubbing on the inside of my finder wells. I...
View Article2001 Ford ranger edge 4x4 for $$3500 located in USA - Louisiana.
Category: Clean Title Status: Domestic I have a 2001 Ford ranger edge 4x4 for sale, in USA - Louisiana. Mileage: 104xxx miles Engine Size: 3.0 Asking price is $$3500 Seller Information: brandon everett...
View ArticleAC Condenser Hoses
I have a 99 2.5l 2wd, and unfortunately just smashed up the front end a bit after misjudging a departure angle. I have pretty much everything fixed except for a metallic hose on the left side (as...
View Article98 ford ranger 2.5 to 2.3 swap
im am putting a 96 2.3 engine in my 98 that had a 2.5 what all do i need
View ArticleIs a cold air intake worth the $
I have a 97 ranger 4.0 and I was looking at the volant cold intake and I was wondering if it was worth the money
View Articlep0430 code
I was driving and then my truck started to sputter so I pulled over and it died then I noticed the check engine light came on it would start back up thougb it wanted to, 45 minutes later I came back...
View ArticleClik here to view.
Hello from Ohio
I just purchased my 1998 Ranger and look forward to scouring this forum for ideas, tips and whatnot. Looks like a great fountain of knowledge. Attached Thumbnails
View ArticleClik here to view.
2015 Ford F-150 aluminum body in Detroit 700 lbs lighter
From the Article: A pre-production F-150 was seen yesterday in in suburban Detroit flaunting its aluminum body that has managed to shave off up to 700 lbs (317 kg). Full article .
View ArticleClik here to view.
Front Hitch and the "cross member"
I'm interested in installing a front hitch on a 94 XLT 4x4 with the 4.0. I ordered a Curt 31063 based on a fit guide, but when I hold it in place to mount it, I don't see how it is going to work. The...
View ArticleClik here to view.
front stud nut needs replaced
I need help by putting in longer stud nuts into OEM rotors that I recently purchased. Here's what happened ... My two stud nuts broke off on me due to improper torqued specification and I replaced all...
View Article