Anti Theft Light Blinking Rapidly
I have a 1998 For Ranger XLT with 55,000 miles. When I shut the ignition off, open the door and lock the door with the power door lock, the anit theft light comes on and starts blinking rapidly and I...
View ArticleDid all 2000 Ranger extend cabs have jump seats?
I have a 2000 Ford Ranger XLT extend cab, and it has the "useless" rear jumpseats. I removed them, and saw that there is now an ugly lower "hole" in each of the side corner trim panels. Would a set of...
View Articledoor sensor problems
i have a 2007 ford ranger bought it used from a dealership, im having a problem with the door sensors always saying they're open when u turn a corner or hit a bump, i try opening and slamming the door...
View Article2000 Ranger V6, jerking when accelerating after shifting
Hi guys, was looking for some suggestions on a problem I am having. Its a 2000 4x4 3.0 V6 with 175,000 on it. When I shift gears and accelerate the truck jerks for a few seconds, it shifts fine so I...
View ArticleWant to Buy: Smoked Halo Headlights/LED tail lights
I'm looking to buy headlights, tail lights, and even fog lights for my 2001 ford ranger edge. I'm interested in halo headlights, that also have the corner light and turn signal and all smoked black. Im...
View Articlelower control arm
Is it possible to remove lower control arm with using special tool for torsion bar, need to replace a bushings and ball joint, or just order new control arm, I would think you could remove with a floor...
View ArticleIdle adjustment screw?
1999 Ranger 3.0 Manual trans is there an idle adjustment screw on these engines? If so, where is it located and how do i use it?
View ArticleClik here to view.
driveline issue
i recently replaced my rear u joint which was really worn out and causing a bad vibration. drove the truck for 2 weeks and the vibrations came back. i assumed that the u joint went again due to having...
View ArticleLift
Hey guys I've got a 99 4x4 xlt was wondering what size lift I should go. Don't wanna go to bigbut want to get my moneys worth. Got wheel spacers and all that good stuff already.
View ArticleIs this kit all I need for my Ranger?
I have a 2001 Ford Ranger Edge. 4x4 Manual, 3.0 V6. All stock. I found this lift kit on ebay for pretty cheap, and was wondering if it was all I need. Is it legitimate, and do I need to purchase...
View Articleswapped to manual transmission in my 99 ranger now it want crank
Swapped to manual and now want crank from ignition when I try to turn it over the light just go off it will crank when I trip it from the solenoid but sputters and dies can anyone tell me whu it want...
View ArticleMore Meets!
We need to get some bigger meets going! Post where you are/ how far you're willing to travel and lets see what we can come up with.
View ArticleWant to Buy: Used Bushwackers 2001 Ford Ranger Edge
I'm interested in buying a set of (4) bushwacker fender flares pocket style... the kind with the bolt-on look that will fit my 2001 Ford Ranger Edge. I'm interested in buying a USED SET ONLY, for I do...
View ArticleNeed help and Ideas
Hey all, I am new to the forum. My name is Tim. I am currently in Afghanistan and I am researching things to do/add to my Ranger. It is a stock 2001 4x4 4.0 XLT 5 speed manual. I want to put a lift on...
View ArticleIdles rough, barely runs
Hi all. I have a 93 3.0 with about 180k. Has always had a rough idle but not too bad. Always ran pretty well, though. Now when I start it, it idles ok for about 30 sec., then idles badly. Drives VERY...
View Articlelower control arm
Is it possible to remove the lower control arm by backing off tension and using a floor Jack to take off the rest of tension
View ArticleVibration...New tire or New bearings?
Hi, I have a 2006 XLT 4WD. Recently I bought a tire for the rear right side at the junkyard and I've also had the REAR wheel bearings/seals replaced. I now have a vibration (not crazy but definetly...
View Articleengine swap help
Hey everyone I have a 1987 ford ranger 2L 4 cylinder engine, I just got a old beat up pre runner, I believe it has a fuel injected 4 cylinder engine 2.4L, I was gonna do a swap into the 87 cause the 2L...
View ArticleTiming belt problems
It was time to replace the timing belt on my 1998 Ranger 2.5 4 cyl. it was running rough and back firing. when the harmonic balancer was removed the aluminum sprocket on the back had some teeth that...
View ArticleNew Member
Hi, I live in Denver CO, and own a 1998 Ranger "Splash" step side pick up that I really enjoy. Looking for some help with common problems (I hope!). And reading what problems other Ranger owners are...
View Article