Clik here to view.
For Sale: James Duff Traction bars - KY
Set of James Duff traction bars. Used, but I never installed them on my truck. All hardware included. For 28 spline axle. $100 shipped (Alaska, hawaii, Canada extra) Attached Thumbnails
View Article1999 4.0 ohv piston/rod
when I received piston/rod assy back from machine shop all the rods are facing the same my question is do all six rod oil holes point to right of cyl block or should it be 3 to right bank ad 3 to left...
View ArticleError code P0320
Occasionally my truck just dies, service engine light has now come on. Any input on what this may be?
View ArticleSanity Check: Transfer Case Re-seal
Hi All, I'm looking for a sanity check here. I don't have the ability to do this myself, so I'm going to have to pay a shop in my area (Chicagoland area) to do the work for me. They've estimated...
View Article347 dyno
got the motor back together and dynoed it today it made 508 hp at 6,500 and it had a tq table not a curve it made mid to low 400 tq from 4,600-6500. we stopped it because it is a stock block.
View ArticleClik here to view.
My Dream Ranger
Hello Forum Members, I purchased my 3rd Ranger last fall on a drive down to Raleigh North Carolina. My 2006 FX4 level II , it has been everything I wanted, but the need to personalize has started. I...
View Articlebed winch mount
I have a 2003 Ranger fx4 and would like to mount an ATV winch on a roll bar or a rack in the bed of the truck but have not found anything strong enough to mount it to except with the bolts that hold...
View Articlefuse for windshield wipers?
Hey guys my 99 ranger has decided it is going to use the wipers whenever it damn well pleases and screw if i have them turned off. So i was wondering is there a fuse that can disable the wipers? I...
View Article3.8 or 4.2 swap
Hi everyone I'm a new ranger owner, mostly a mustang guy (94 cobra). I've got a 2005 3.0 (non-ffv) with auto that needs an engine (compression test didn't turn out good). I thought about just going...
View Articleleaves in cab from fan blower unit
hello i'm a new member and I was wandering if anyone has ever had a problem with leaves coming into the cab from the fan blower unit. I have a 2011 Ranger XL and I took it to the dealers and that the...
View Article1997 4.0 V6 fuel pressure problem
I put a guage on it, and key on eng off was getting 10psi.... then I reset it and tried it again and got 40psi... then I reset it and got 10psi... then I reset it and tried again and got 35psi... I...
View ArticleRounded Nut and Bolt Remover (Go2 Socket Review)
Hey guys, So I got this socket in the mail from the inventor and they asked me to give it a try. It is supposed to remove rounded bolts and nuts. It worked surprisingly well and I liked it. It even...
View ArticleWhat suspension should i get?
Im looking for a SUSPENSION lift for the front of my ranger. heres where I'm at, I want that nice prerunner looking lift where its angled up a little at the front, so would just a front suspension lift...
View ArticleRanger monoleafs - are these any good?
While rummaging through the local parts yard I came across a couple of Rangers with composite monoleafs in the rear. Does anyone have some input on these? Good or bad. I know that in general they are...
View Articlelooking to do front axle swap!
So I have a 2003 ranger EX cab and it's a 4x2 with the Tbars. I'm looking for someone who has don't a straight axle swap todo mine. Not worried about being 4x4 right now just wanna get the axle in...
View ArticleNew to Ranger and Ranger forum
Just purchased a 2000 Ranger xlt 4x2 extended cab with side step box and just over 32000 miles....Been looking for a long time to find one without much rust... finally found it .Just wondering what I...
View Article2001 edge sas
Hi im new to doing swaps and rangers. I was out on some trails last weekend and thought about lifting my truck. Easiest and cheapest way from what i read best way is sas swap. What would be...
View ArticleNew to trucks, New to the forum
Just got a 2004 Ranger with 47k miles on it. Looking to join up to learn more about what I've got and learn a bit about trucks in the process. :tongue:
View ArticleClik here to view.
Custom seat covers for Ford Ranger: various materials and colors
We are glad to introduce custom Coverking® seat covers for Ford Ranger at CARiD. Unlike other universal seat covers, these are tailored for your particular model and will fit like a glove. We have...
View Article