2002 3.0 with 260,000 miles. this is the third time the tranny has been rebuilt. went to floor it to merge into traffic and it acted like it was in neutral. If I put the selector in first or second and build up speed I can then shift into drive and the tranny works fine. overdrive will work as well. I just cant use the "drive" position to start from a stop. Reverse is also the same way. Long story short, drive and reverse act like a manual clutch with a worn out clutch. This is the same thing that happened the other two times I had the tranny rebuilt and both times were at different Ford dealers. No warranty left on the repairs. Seems weird that if I use "1" or "2" and shift to drive from there it works like it should until the speed drops and it downshifts to first. Could this be something electrical perhaps? What makes it worse was that not a month before this happened I replaced the cylinder heads and the truck was running so friggin awesome! Any ideas?
↧