I just replace both front calipers and pads, master cylinder, and front brake lines on my 1998 Ranger (rear lines were already done). I bench bled the master cylinder before installing, bled the cylinder after installing (has bleeder screw on it), bled the entire system and get solid streams of fluid out, but when I start the truck, the pedal goes straight to the floor, it's not even spongy, just straight down. I thought it was a faulty new master cylinder so I replaced it again and repeated the whole process and I have the same results. This is not that difficult, but I am totally at a loss. I have no leaks anywhere either. Any suggestions?? Thank you!
↧