Transmission issues, 20 DTCs, help!

Hey guys,

Had an issue with my truck today. 2006 Ranger, FX4, automatic, 112xxx kms.

I was pulling a (small) trailer today, no issues until I parked and came back 2-3 hours later. Engine light on and O/D off flashing immediately after start-up. Trans slipping and truck vibrating/bucking when trying to move, won't rev. Limped it home, after having to use 4low to get across the city, the managed to get up to speed on the highway.

I checked the codes and got 20 DTCs, recorded them, cleared them and 16 came back immediately. Checked all fuses, all good.

The codes are all transmission and oxygen sensor related. Mostly shift solenoids and pressure sensors. Something is fishy here, must be electrical, not all of that would go wrong at once.

The codes were:
P0446 - EVAP System Vent Control Circuit
P0740 - Torque Converter Clutch Solenoid Circuit
P0743 - Torque Converter Clutch Circuit
P0750 - Shift Solenoid 1 Circuit Malfunction
P0755 - Shift Solenoid 2 Circuit Malfunction
P0760 - Shift Solenoid 3 Circuit
P0765 - Shift Solenoid 4 Circuit
P0962 - Pressure Control Solenoid A Control Circuit Low
P0765 - Shift Solenoid 'D' Malfunction
P0962 - Pressure Control Solenoid A Control Circuit Low
P0748 - Pressure Control Solenoid 'A' Electrical
P0753 - Shift Solenoid 'A' Electrical
P0758 - Shift Solenoid 'B' Electrical
P0763- Shift Solenoid 'C' Electrical
P0768 - Shift Solenoid 'D' Electrical
P0135 - O2 Sensor Heater Circuit Malfunction Bank 1
P0141 - O2 Heater Circuit Bank 1 Sensor 2
P0155 - O2 Heater Circuit Bank 2 Sensor 1
P0161 - O2 Sensor Heater Circuit Bank 2 Sensor 2
P2195 - Lack of HO2S-11 Switch Sensor Indicates Lean
P2197 - O2 Sensor Signal Biased/Stuck Lean Bank 2 Sensor 1
P0403 - Exhaust Gas Recirculation Circuit Malfunction

Any ideas?